Water in Fuel

To keep both diesel and ethanol fuels stable and storable, it is important to control and eliminate collected water in storage or fuel tanks.  This collected water causes some common and also some unique problems for each of these fuels. 

Water & Ethanol Blends

Ethanol has a chemical attraction to water and any ethanol blend, whether 10% or 15% or more, will absorb water from the air and pull it into the fuel. All ethanol blends can absorb a certain amount of water, but when the water from the air exceeds what the fuel can absorb, you get a phenomenon called "phase separation". The previously-absorbed water will fall out of solution and it will pull some or most of the ethanol out of solution with it. You end up with a layer of water & ethanol at the bottom of the tank or container (the water-ethanol sink to the bottom because they are heavier than gasoline). Meanwhile, the gasoline left behind is poor quality because when the water and ethanol fall out of solution, they will strip much of the octane rating from the gasoline. So instead of a tank full of high-quality E10 or E15 blend fuel, you finish with a tank of water and ethanol on the bottom and poor quality, low octane gasoline on top.

Functionally, this is a problem because the engine won't run properly on this low-octane gasoline. The worst case scenario, however, is that the fuel line will suck some of the water-ethanol in the combustion chamber, with severe engine damage as the result.

So you can see why it's important to keep this from happening.

Water & Diesel Fuels

Diesel fuel problems with water tend to be caused more by their long-term storage than by any chemical interaction with water.  Storage of diesel leads to condensation of water in the storage tank, with the water settling on the bottom of the tank.  When this happens, you can get:

  • Accelerated breakdown of the fuel quality (because the presence of water leads to certain types of chemical reactions that cause the fuel to darken and that cause gums and varnishes to form and drop out of the fuel)
  • Possible injector damage if the water develops in the vehicle fuel tank and is sent through a hot injector (the water forms steam in the pintle tip and expands, blowing the injector out)
  • Development of microbial growth in the storage tank, as microbes need water present to multiple and flourish.  This leads to corrosion, plugged filters and the destruction of the diesel fuel quality.

Commercial-grade fuel treatments from Bell Performance are made to cure all of these problems.  Because when you need to use your stored fuels, Performance Counts!

Ethanol Defense

6 products

DFS Plus Diesel Fuel Surfactant

3 products

Marine MXO Marine Gas and Ethanol Treatment

7 products

Mix-I-Go Concentrate Gasoline and Ethanol Treatment

7 products

Dee-Zol Concentrate Diesel Treatment

7 products

Bellicide Biocide Treatment

2 products

Product Bundles

14 products